Westermo ID-90 - Manual (Page 69)

69 6607-2204
atsx, atopt, atrej – AT command parameter set
AT command set only:
Handle AT specific settings.
Show and change AT S registers by entering the new value.
ats0
show setting of S0-Register
ats0=1 set Register S0 to 1
atopt show option register (bit-values):
bit 0: 0 1 => ATV1
bit 1 : 02 => ATW1
bit 2 : 04 => ATQ1
bit 3 : 08 => ATE1
bit 4 : 10 => ATS9=0
atrej show reject register => setting of AT#R (0,1)
autoreset – TA reset option
The autoreset command is default 0 but if value is 1 then the unit make a reset every time
a disconnect occurs.
If the value is more that 1 and less that 255 the unit resets periodically every minute spec-
ified by this command.
Example: autoreset=0 (default)
autoreset=1
autoreset=20
bc – Bearer capability
Bearer capability for outgoing data calls. (default: 00 00; hex bytes) (see note 2, page 84)
bod – Bandwidth On Demand enable
0 disable BOD (default)
1 enable BOD
bodiv – BOD increase value
bodiv= Set the bit-rate in kbit/s at which a second B channel is
connection (default=40).
bodit – BOD increase timer
bodit= Sets the time in seconds the bit-rate has to be over the
increase value before the second B-channel is connected
(default=30)