Westermo ID-90 - Manual (Page 37)

37 6607-2204
W – Enhance result messages
ATW0 Shows result code (RING, CONNECT) without additional info (default)
ATW1 Shows result code (RING, CONNECT) with address
&W – Store active configuration
The active configuration will be stored in non volatile memory.
AT&W0
AT!&W
!&W – Store active configuration
The active configuration for the analogue option will be stored in non volatile memory.
AT!&W
X – Reduce result messages
Reduces the number of result messages after trying to set up a connection
ATX0“CONNECT” only
ATX1
“CONNECT” with line speed, “BUSY”, “NO DIALTONE” not used
ATX2 “CONNECT” with line speed, “BUSY” not used
ATX3 “CONNECT” with line speed, “NO DIALTONE” not used
ATX4 “CONNECT” with line speed, all messages used (default).
##X – Send an alarm message
Sends the preprogrammed alarm message which is associated with alarm input addressed
with the command parameter.
AT##X1 Send alarm message 1
AT##X2 Send alarm message 2
AT##X3 Send alarm message 3
AT##X4 Send alarm message 4
Z – Load stored settings
The active configuration will be resetted to the stored configuration.
Must be the last command in an AT command line.
ATZ
When the V90 option is present this command will also cause a soft reset
of the V90 modem with a recall of stored configuration profile .
&Z – Store call-number
Stores dialing number nn as entry number x into the telephone list (x = 1..3).
AT&Zx=nn set entry number x to dialling number nn
AT&Zx shows entries number x.
AT&Z show all entries.
90
90