beautypg.com

D – initiate outgoing call – Westermo ID-90 User Manual

Page 25

background image

25

6607-2204

D – Initiate outgoing call

Dials the number (D for Dial). The dial modifier “W", “>”, “T”, “;”, “@” can be freely
inserted in the dial string; they have no influence on the dial procedure of the ID-90.
Must be the last command in AT command line.
Any character input while the ID-90 is dialing will cancel the dialing procedure.

ATD[/][//]

[,X[Pxxx-][R ][N ][G ]][D]]

CALLEDnumber:

ISDN call number for a dialled B channel connection or
X.25 number for X.31 D channel

subaddr

dialled subaddress

UUS1data

transmitted data with UUS1 signalling

P:

use packetsize xxx for X.25 connection

R:

request the facility reverse charging

G:

access to X.25 closed user group

O:

Outgoing call from X.25 closed user group

N:

use NUI and password with call setup
allowed chars: a-z, A-Z, 0-9.
(overrides setting of nui configuration command)

X25number:

dialled X.25 call number (X.25 B channel only)

D:

separator for userdata: “D” or “,”: user data without

protocol ID

“P”: user data with protocol ID (“01000000”)

ATDL

Dial the last dialled number

ATDS=n

Dial number n from stored telephone number list (n = 1..3)
(See command AT&Z to store numbers)

AT!D
ATD#
ATDT#

CALLEDnumber: Call number for a dialed connection to an analogue PSTN number

over ISDN using the internal analogue modem

AT!DL

Dial the last dialed number

AT!DS=n

Dial number n from stored telephone number list (n = 1..3)
(See command AT&Z to store numbers) and catab n

Notes: – To setup the own subaddress see configuration command sub.

– Adding an “e” to CALLEDnumber indicates that a connection to the internal

remote access of a ID-90 shall be performed, the protocol X.75 (ATB10)
has to be used.

90