Westermo ID-90 - Manual (Page 65)

65 6607-2204
TA+Configurator command set
The settings of the ID-90 for the serial interface and the S0 interface are called configura-
tion. The ID-90 is delivered with a set of pre-set values. In the following section it will be
shown how, by using the configuration commands, you can examine the configuration of
the ID-90 and if necessary change it. The values can be stored in non volatile memory; this
means they'll remain unchanged even if the power supply is disconnected.
You can configure the ID-90 in the following ways:
• by using TA+ configuration commands entered by a locally connected PC.
• by using TA+ configuration commands entered via the ISDN access
(remote configuration).
• by using the AT command set entered by a locally connected PC.
The configurator can be entered in the following ways:
• remote via ISDN.
• by using a special command from the asynchronous dialup command interface
(AT: “ATCONF”).
Configuring the ID-90 with AT commands
To execute one TA+configuration command cmd out of the AT command mode you have
to issue the command: “at**cmd” .
To call up the TA+configurator please use the command “atconf”.
You can leave the TA+configurator by the command “quit”.
Note: After altering one of the profile values you have to give the additional
commands save and reset. This is necessary to save and activate these
new parameters.
Configuring the ID-90 with X.3 PAD
To execute one TA+configuration command cmd out of the X.3 – PAD command mode
you have to issue the command: “exec cmd” .
To call up the TA+configurator please use the command “conf”.
You can leave the TA+configurator by the command “quit”.
Note: After altering one of the values you have to give the additional commands
save and go. This is necessary to save and activate these new parameters.