N – set line baudrate v.110 – Westermo ID-90 User Manual
Page 33

33
6607-2204
in units of bit/s. The possible values for each modulation are listed in
Table 1.
Actual values will be limited to possible values corresponding to the
entered
tion. (default = lowest (
rate supported by the selected carrier.
Numeric values which specify the lowest (
and
(
connection. Non-zero values for this subparameter are decimal encoded,
in units of bit/s. The possible values for each modulation are listed in
Table 1.
Actual values will be limited to possible values corresponding to the
entered
tion. (default = lowest (
rate supported by the selected carrier.)
Reporting Current or Selected Values
Command:
!+MS?
Response:
+MS:
carrier>,
Note: The current active settings are reported under control of the !+MR parameter.
Example:
!+MS=V90, 1 300,
This example uses default values, allowing maxi
33 600, 300, 56 000 mum system flexibility to determine optimal
receive and transmit rates during operation.
Reporting Supported Range of Parameter Values
Command:
!+MS=?
Response:
+MS: (< carrier> range),(
range),(
(
Example:
+MS: (B103, B212, V21, V22, V22B, V23C, V32, V32B, V34, K56, V90),
(0,1), (300-33 600), (300-33 600), (300-56 000), (300-56 000)
N – Set line baudrate V.110
Selects the line baudrate of the ID-90 to the desired value (only valid for B channel proto-
col V.110 asynchronous).
ATN0
Line baudrate automatic set (equals to local baudrate or less, default)
ATN1
Line baudrate set to 1 200 bit/s
ATN2
Line baudrate set to 2 400 bit/s
ATN3
Line baudrate set to 4 800 bit/s
ATN4
Line baudrate set to 9 600 bit/s
ATN5
Line baudrate set to 19 200 bit/s