Westermo ID-90 - Manual (Page 97)

97 6607-2204
X.25 causes in Reset packet
00 Triggered by DTE
01 Out of operation (virtual connections only)
03 Remote sequence error
05 Local sequence error
07 Temporarily network disturbance
09 Remote station ready (virtual connections only)
0F Network ready (virtual connections only)
11 Incompatible destination
No. Restart- Clear- Reset- Diag- Meaning
hex ind. ind. ind. nostics
AA – X – – Number temporarily not accessable
AB – X – – User recognition required in the packets
“Connection-Request” and “Call-Accepted”
AC – X – – Called subscriber has not aggreed upon the facility
“Single Packet”
AD – X – – Network internal Load-Request received *)
AE – X – – Network component error *)
AF – X – – Network failure of a virtual connection *)
B0 – X – – Network internal restart request received *)
B1– X – – Erroneous number of called station in the packet
»Call-Accepted«
B2 – X – – Unknown network facilty
B5 – X – – X.32 dial access not available
B6 – X – – X.32 dial access not available
B7 – – X – Reserved
C0 – X – – X.25 dial access: Service data error
C1– X – – X.25 dial access: Service data error
C2 – X – – X.25 dial access: User data erroneous
C3 – X – – X.25 dial access: Procedural error
C4 – X – – X.25 / X.32 dial access: Modem error
C5 – X – – X.25 / X.32 dial access: Modem error
C8 – X – – X.25 dial access: successful connection
establishment
C9 – X – – X.25 dial access: dialling procedure running now
FF X X X X System error
Notes:
X
The diagnostic indication will be used by the above shown packet.
- The diagnostic indication will not be used by the above showed packet.
PVC The above showed packet will use this diagnostic indication only with PVC (Permanent
Virtual Call).
X.75 The diagnostic indication will be used with international connections.
*) Only valid for special network components (concentrator).
Table 5 cont.