Westermo ID-90 - Manual (Page 85)

85 6607-2204
x31rr – Enable rerouting for X.31 D channel
Enable automatic establishment of an X.25 B channel connection if the X.31 D channel
connection fails using the entries of table xtab.
0: no rerouting (default).
1: automatic rerouting enabled.
(X.31 D channel only)
Notes:
(Note1) After issuing one of these parameter you should execute the “save” command
to store the configuration in non volatile memory. To activate and use the new
setting you have to run the “reset” command.
(Note2) Command syntax for setting hlc, llc and bc
An empty parameter has to be entered by “-”.
Example: Deleting of bc-value:bc -<
↵
>
Entering a new bc: bc 8890<
↵
>
(Note3) Different modes for V.110 baudrate adaption
Outgoing call:
brn # 0: ISDN message SETUP will be created with or without LLC(brn)
depending on the setting of v110llc;
The B channel (V.110 baudrate) will use the baudrate set by brn
(independent of br or recognized local baudrate)
brn = 0: “Adaptive”: same mechanism as brn # 0; the V.110 baudrate will be
created by br rsp. the recognized local baudrate.
Incoming call:
brn # 0: No LLC received: accept incoming call, use in B channel brn for V.110
baudrate.
LLC received compliant to brn: accept incoming call
LLC received not equal to brn: Reject incoming call:
DISCONNECT (cause = incompatible destination).
brn = 0: “adaptive”: No LLC received: accept incoming call, use in B channel
br rsp. the recognized local baudrate for V.110 baudrate.
LLC received: accept incoming call, use in B channel the baudrate
derived from the LLC as V.110 baudrate.
The usage of the LLC is controlled by the TA+Configurator command v110llc