Westermo ID-90 - Manual (Page 22)

22 6607-2204
A/ – Repeat last command line
This command repeats the commands of the last entered command line.
Note: No prefix AT is required.
A/
##An – Only analogue outgoing call (only ID-90V90)
Can enable the adapter to make analogue calls even if no control character (’#’ or ’!’)
is used in the dial string.
This also implies that no digital outgoing call can be made when AT##A1 is set.
Digital incoming calls can still be received.
AT##A0: configures the adapter to be able to make both analogue and digital
outgoing calls. (default)
AT##A1: configures the adapter only to make analogue outgoing calls.
A – Accept incoming call
Using this command you can accept an incoming call, if automatic call acceptance is not set
(Register S0 = 0). An incoming call is displayed by the message “RING” or the code “2”.
Must be the last command in an AT command line.
ATA[//]
UUS1data
transmitted data with UUS1 signalling
B – B channel protocol
Transmission protocol for data communication in the B channel.
ATB0: V.110 asynchronous (For file and data transfer i.e.
for BBS access)
ATB3: HDLC async to sync (Async PPP to sync PPP, single link
conversion
i.e. for Internet / PPP dial-up network access)
ATB4: HDLC transparent (octets are packed into HDLC frames)
ATB5: Byte transparent (raw B channel data)
ATB10: X.75- SLP (For file and data transfer i.e. for BBS
access, default)
ATB13: V.120For file and data transfer
i.e.AOL/CompuServe access
ATB20: X.31 B channel (X.25 B channel, access to X.25 packet
switched network over B-channel)
ATB21: X.31 D channel (X.25 D channel , access to X25 packet
switched network over D-channel
ATB22: T.70-NL-CEPT (For telematic services over ISDN i.e. T-
Online videotex access)
ATB23: T.90-NL For telematic services over ISDN
ATB31: ML-PPP (ML-PPP, Async to sync PPP conversion in
Multilink PPP mode, for internet access)
90