Westermo ID-90 - Manual (Page 49)

X.3 PAD
If you connect an asynchronous DTE to the X.31-service, you can use the integrated PAD
of the ID-90. You can use for example the command stat to see the status of the connec-
tion.
To setup PAD mode please use the configuration command “cmds = 1”.
X.3 command set – integrated PAD
The following PAD-Commands regarding the specifications X.28/X.29 are supported:
• (dot) Displays PAD identification
[Pxxx-][R ][N ][G ]X25number[I][D]
Establishes an X.25 connection
P: use packetsize xxx for X.25 connection
R: request the facility reverse charging
G: access to X.25 closed user group
O: Outgoing call from X.25 closed user group
N: use NUI and password with call setup, allowed chars: a-z, A-Z, 0-9.
(overrides setting of nui configuration command)
X25number: dialled X.25 call number
ISDNnumber: ISDN call number for a dialled B channel connection
D:
separator for userdata: “D”, “P” or “,”
clr Clears an X.25 connection
conf Enters directly into the TA+Configurator, the configuration prompt “#”
will be displayed. Leave the TA+Configurator with the command “quit”.
stat Showing the PAD connection status
set Set the PAD Profile to Profile 0
set x:n Set the PAD Profile parameter x to value n
Note: PAD parameter can be stored using the command “exec save”.
prof x Configures to the PAD Profile x, x = 0..7, 90, 91
Note: PAD parameter can be stored using the command “exec save”.
prof? Displays the configured PAD Profile values
par [x][,x] Displays all configured PAD Profile values or the PAD parameter x
“par” without parameter displays all parameter.
ver Displays the version number
49 6607-2204