Westermo ID-90 - Manual (Page 48)

48 6607-2204
Call number display:
<rn> = call number of remote site
In AT command mode, call number display (does not belong to the AT command standard)
can be turned on by issuing the command ATV2 or ATV3. If turned on, the call number of
the caller is shown with the Connect- or Ring-message (in pointed brackets), depending on
the signaling in D-channel.
If the ID-90 is used at the public network then the call number of the remote site (includ-
ing area code) is displayed.
Example: CONNECT 64000 <040890880>
Error cause display:
= ISDN release (error) cause, hexadecimal
Example:
NO CARRIER <#34F0>
In AT command mode, error cause display (does not belong to the AT command standard)
can be turned on by issuing the command ATV2 or ATV3. The shown error causes use the
coding defined by the CAPI definition. ISDN error causes from the ISDN network are
always coded as 34xxH, where xx represents the hexadecimal version of the ISDN error
cause (see page 92). All other causes are CAPI error causes (see page 98).