Westermo ID-90 - Manual (Page 82)

82 6607-2204
status – Status of serial line and ISDN
Returns the status of the serial line and ISDN channels.
Example: current status information ID-90
Current status information ID-90
serial line: DTR:on, RTS:on, DSR:on, CTS:on, DCD:off, RI:off
ISDN: L1:down
Dch: Prot:DSS1 State:disconnected, CdPN:, CgPN:, prev error: 0
Bch: Prot:X.75 SLP State:disconnected, CdPN:, CgPN:
sub – Subaddress
Select own subaddress that will be sent with an outgoing call as called party subaddress
with max. 20 digits
*: no subaddress setup
The subaddress is automatically stored to non volatile ram.
svcio – Logical channels svc
Maximum number of switched virtual logical channels for incoming and
outgoing X.25 connections.
svcio = {1..15}, (default: 1)
swstatus – TA-DIP Switches status
Returns the status of the TA-Configuration switches
This command has the same function and result as ATI7 command.
See ATI7 command for presented result.
tdi – Timer delay incoming call
Delay time between receiving ISDN incoming data call and signalling via RING
or CONNECT message.
0: no delay (default)
1..n: delay time in 50 ms ticks.
tei – TEI value
X.31 D channel only:
Terminal equipment identifier. This value must be identical to the tei of your
basic rate access, will be defined by your ISDN supplier.
default: 1
transno – Transmitter telephone number for this TA
With this commend you can set the ISDN number for this TA. This information will be
sent together with a SMS alarm connection.
Maximum length of transmitter number = 20 digits.