Westermo ID-90 - Manual (Page 79)

79 6607-2204
prot – B channel protocol
Transmission protocol for data transfer
0: V.110 asynchronous (For file and data transfer i.e.
for BBS access)
3: HDLC async to sync conversion (Async PPP to sync PPP, single link
i.e. for Internet / PPP dial-up network
access)
4: HDLC transparent (octets are packed into HDLC frames)
5: Byte transparent (raw B channel data)
10: X.75- SLP (For file and data transfer i.e.
for BBS access, default)
13: V.120For file and data transfer
i.e.AOL/CompuServe access
20: X.31 B channel (X.25 B channel, access to X.25 pack-
et switched network over B-channel)
21: X.31 D channel (X.25 D channel, access to X25 packet
switched network over D-channel
22: T.70-NL-CEPT (For telematic services over ISDN i.e.
T-Online videotex access)
23: T.90-NL For telematic services over ISDN
31: ML-PPP (ML-PPP, Async to sync PPP conver-
sion in Multilink PPP mode, for inter-
net access)
prty – Asynchronous parity
Parity of asynchronous character (default: no parity)
0: No parity; 1: Even parity; 2: Odd parity
ptp – ISDN interface type
Select type of ISDN interface:
0: select multipoint mode (to connect ISDN terminals, default)
1: select point to point mode (to connect ISDN switching systems)
pvc – X.25 connections permanent virtual circuits usage
Enable usage of permanent virtual connections instead of switched logical
connections. X.25 channel number 0 will be used.
pvc = 1: enable (default 0)
quit, exit – Activate parameter changes
Activates the actual parameter settings and leave the configurator
(without storing the parameter in non volatile memory).