Westermo GD-01 - Manual (Page 60)

60 6196-2220
+CNMI – New message indication
Description:
This command selects the procedure for message reception from the network.
Syntax:
AT+CNMI=,,,,
Command example Possible responses Note
AT+CNMI=2,1,0,0,0 OK =1
AT+CMTI: “SM”,1 message received
AT+CNMI=2,2,0,0,0 OK =2
+CMT: “123456”, ”98/10/01, message received
12:30 00+00”,
129,4,32,240, “15379”,
129,5
AT+CNMI=2,0,0,1,0 OK =1
AT+CMGS= +CMGS: 7 Send a message in text
”+33146290800” mode, successful trans-
Message to send OK mission
+CDS: 2, 116, message was correctly
”+33146290800”, 145, delivered
“98/10/01,12:30:07+04”,
“98/10/01
12:30:08+04”, 0
Defined values:
controls the processing of unsolicited result codes. Only =2 is supported. Any
other value for (0,1 or 3) is accepted (return code will be OK), but the pro-
cessing of unsolicited result codes will be the same as with=2.
Possible values:
0: Buffer unsolicited result codes in the TA. If TA result code buffer is full, indica-
tions can be buffered in some other place or the oldest indications may be dis-
carded and replaced with the new received indications
1: Discard indication and reject new received message unsolicited result codes
when TA-TE link is reserved. Otherwise forward them directly to the TE
2: Buffer unsolicited result codes in the TA when TA-TE link is reserved and flush
them to the TE after reservation. Otherwise forward them directly to the TE
3: Forward unsolicited result codes directly to the TE.TA-TE link specific inband
used to embed result codes and data when TA is in on-line data mode
B A C K