Westermo GD-01 - Manual (Page 123)

123 6196-2220
&V – Display configuration
Description:
This command is used to display the modem configuration.
&V
or
&V0:
Display the modem configuration in RAM.
&V1: Display the modem configuration in EEPROM.
&V2: Display the modem factory configuration.
The parameters displayed are the following:
Q,V, S0, S2, S3, S4, S5,
+CR, +CRC, +CMEE, +CBST,
+SPEAKER, +ECHO, &C, &D, %C
+IPR, +ICF, +IFC.
Syntax:
AT&V
Command example Possible responses Note
AT&V Q:0 V:1 S0:000 S2:043 Display active parameters
S3:013 S4:010 S5:008 in RAM
+CR:0 +CRC:0 +CMEE: For Echo the first value
0 +CBST:0,0,1 corresponds
+SPEAKER:0 +ECHO:0,0 to Echo cancellation 1.
&C:1 &D:2 %C:0
+IPR:9600 +ICF:3,
4 +IFC:2,2
OK
B A C K