Westermo GD-01 - Manual (Page 172)

172 6196-2220
Defined Values:
Duration between the activation and deactivation of the PDP context in secondes
:
data volume received by the MS in Kb
:
data volume sent by the MS in Kb
+WGPRS – GPRS PARAMETERS CUSTOM, (GPRS command)
Description
This command modify some GPRS parameters as the ATTACH-STATUS (the ME
don’t make automatically a GPRS attachment after init: yes/no), the PDP-INIT-STATUS
(activate automatically some define PDP Contexts after init: yes/no) and the use (yes/no)
of NAT (IP address translation on PPP).
In addition this command permit to set “ACTIVABLE” automatically after init some
define PDP contexts.
NOTE: The unit must be reboot to activate the new setup.
Syntax
AT+WGPRS=,,[]
AT+WGPRS=?
AT+WGPRS?
Response Syntax:
OK
ERROR
Response on ”AT+WGPRS=?”:
+WGPRS: , ,[]
[+WGPRS: ,
,[]
[...]]
Response on “ AT+WGPRS?”
+WGPRS:(list of supported ),[(list of supported )]
[+WGPRS:(list of supported ),
[(list of supported )] [...]]
B A C K