Westermo GD-01 - Manual (Page 134)

134 6196-2220
+WSTR – Status Request
Description:
This command returns some operation status. It can be used for ex. to check the state of
the initialisation sequence; the different values returned are Not started, Ongoing,
Finished.
Syntax:
AT+WSTR=
Response syntax:
+WSTR: ,
Command example Possible responses Note
AT+WSTR= +WSTR :, Select the status 1
(INIT SEQUENCE)
AT+WSTR=1 +WSTR: 1,2
OK
AT+WSTR=2 +WSTR: 2,1 Select the status 2
OK (NETWORK STATUS),
result: the network is
available
AT+WSTR=? +WSTR: (1-2) Ask the list of possible
values, result: possible
values: 1, 2
Defined values:
1: Initialisation sequence
0: Not started
1: On going
2: Finished
2: Network status
(result)
0: No network
1: Network available
B A C K