Westermo GD-01 - Manual (Page 174)

174 6196-2220
AT+WGAUTH – Set authentication parameters, (GPRS command)
Description
This command set the authentication parameters login/password to use with a particular
cid during a PDP activation.
If a PPP negotiation occurred with this cid, the PAP or CHAP authentication parameters
are used instead of them.
NOTE: These parameters are not saved in persistent memory.
If the cid is not defined then ERROR is returned.
Syntax
AT+WGAUTH=,,
AT+WGAUTH?
AT+WGAUTH=?
Response Syntax:
OK
ERROR
Response on ” AT+WGAUTH?”:
+WGAUTH: ,,
[+ +WGAUTH: ,,
[...]]
OK
[...]]
Response on “ AT+WGAUTH=?”
+WGAUTH: (list of supported s)
OK
Defined Values:
(PDP Context Identifier) a numeric parameter (1-32) which specifies a particular PDP
context definition.The parameter is local to the TE-MT interface and is used in other
PDP context-related commands.
and : string parameters used to authenticate the user during a PDP
activation.
NOTE: These parameters are optional and depend of your subscription setup.
Command example Possible responses Note
AT+WGAUTH=1, –
”westermo”,”kru98” OK
B A C K