Westermo GD-01 - Manual (Page 157)

157 6196-2220
+CGACT – PDP context activate or deactivate, (GPRS command)
Description
The execution command is used to activate or deactivate the specified PDP context (s).
After the command has completed, the MT remains in V.25ter command state. If any PDP
context is already in the requested state, the state for that context remains unchanged.
If the requested state for any specified context cannot be achieved, an ERROR or +CME
ERROR response is returned. Extended error responses are enabled by the +CMEE com-
mand.
If the MT is not GPRS attached when the activation form of the command is executed,
the MT first performs a GPRS attach and them attempts to activate the specified con-
texts. If the attach fails then the MT responds with ERROR or, if extended error respons-
es are enabled, with the appropriate failure-to-attach error message.
If no s are specified the activation form of the command activates all defined
contexts.
If no s are specified the deactivation form of the command deactivates all active
contexts.
Two PDP contexts can be activated through the software.
The read command returns the current activation states for all the defined PDP con-
texts.
The test command is used for requesting information on the supported PDP context
activation states.
Syntax:
+CGACT=[ [,[,[,...]]]]
+CGACT?
+CGACT=?
Response Syntax:
OK
ERROR
Response on “+CGACT?”
+CGACT: ,
Response on “+CGACT=?”
+CGACT: (list of supported s)
B A C K