Westermo GD-01 - Manual (Page 112)

112 6196-2220
+FDIS – Current sessions parameters
Description:
This command allows the DTE to parameter the capabilities used for the current ses-
sion.
Syntax:
AT+FDIS=,
,,,,,,
Command example Possible responses Note
AT+FDIS=? (0,1),(0-5),(0-2),(0-2),
(0-3),(0),(0),(0-7) Fax ECM not supported
OK Fax 14,4 kbps supported
Defined values:
This command accepts eight numeric parameters (of the T30 standard):
Vertical Resolution,
0: (default) Normal: 98 lpi
1: Fine: 196 lpi
Bit Rate,
0: 2 400 bps (modem type:V.27 ter)
1: 4 800 bps (modem type:V.27 ter)
2: 7 200 bps (modem type:V.29)
3: 9 600 bps (modem type:V.29,V.17)
4*: 12 000 bps (modem type:V.33,V.17)
5*: 14 400 bps (modem type:V.33,V.17)
(*) Only when product supports 14,4 kbps data feature. If this feature is supported,
default is 5, otherwise default is 3.
Page Width,
0: (default) 1728 pixels in 215 mm
1: 2048 pixels in 255 mm
2: 2432 pixels in 303 mm
Page Length,
0: A4, 297 mm
1: B4, 364 mm
2: (default) Unlimited
B A C K