Westermo GD-01 - Manual (Page 128)

128 6196-2220
+WIND – General Indications
Description:
This command is a general mechanism to send unsolicited non-standardized indications
to the application.The identified unsolicited non-standardized indications are:
• Indication of a physical change on the SIM detect pin from the connector
(meaning SIM inserted, SIM removed)
• Indication during mobile originated call setup that the calling party is ringing.
• Indication of the availability of the product to receive AT commands after boot.
For each of these indications, a “bit flow” has to be indicated.
Syntax:
AT+WIND=
Defined values:
1 (bit-0): Hardware SIM Insert / Remove indications (Rack open/close)
or SIM presence after software reset
2 (bit-1): Calling party alert indication
4 (bit-2): Product is ready to process AT commands
(except phonebooks, AOC, SMS), but still in emergency mode.
8 (bit-3): Indication that the product is ready to process all AT commands,
at the end of init or after swapping to ADN in case of FDN
configuration
16 (bit-4): Indication that a new call identifier has been created
(after an ATD command, +CCWA indication)
32 (bit-5): Indication that an active, held or waiting call has been released
by network or other party
64 (bit-6): Network service available indication
128 (bit-7): Network lost indication
256 (bit-8): Audio ON indication
512 (bit-9): SIM Phonebooks reload status
1024 (bit-10): Sim phonebooks checksum indication
2048 (bit-11): Interruption indication (only if FTR_INT is activated)
If is equal to 0 (default value), no unsolicited “+WIND: ” will occur.
Combination (addition of the values) is used to allow more than one
indication flow. 0 ≤ IndLevel ≤ 4095
The response is OK if the values are in the previous range.
B A C K