Westermo GD-01 User Manual
Page 146
146
6196-2220
+WATH – Special Hang-up
Description
This specific command is used by the application to disconnect the remote user, specify-
ing a release cause and the location. In the case of multiple calls, all calls are released
(active, on-hold and waiting calls).
Syntax
AT+WATH=
Command example
Possible responses
Note
AT+WATH=31
OK
Ask for disconnection
with release
Note: Every call, if any,
are released,
cause=normal and
location=USER
AT+WATH=? +WATH: (1-127),(0-5,7,10)
AT+WATH=17,2
OK
Ask for disconnection
with release
cause=user, busy and
location= public network
serving the local user,
every call, if any, are
released
Defined values
decimal value from 1 to 127, see the table in the end of the manual “Failure Cause from
GSM 04.08 recommendation”
optional parameter (default value =0), values as defined in 04.08
0:
user
1:
private network serving the local user
2:
public network serving the local user
3:
transit network
4:
public network serving the remote user
5:
private network serving the remote user
7:
international network
10:
network beyond interworking point
NOTE: “AT+WATH=0” is the same as “ath”
B A C K