Westermo GD-01 - Manual (Page 127)

127 6196-2220
+CCED – Automatic RxLev indication
Description:
The CCED command has been extended to indicate the received signal strength indica-
tion (rssi) of the main cell.The command principle has not changed.
Syntax:
AT+CCED=[, ]
Defined values:
0: One shot requested
1: Automatic shots requested
2: Stop automatic shots
8: Main cell RSSI indications (RxLev) from 0 to 31
The response will be a +CSQ response and not a +CCED response.
The 07.07 format for +CSQ is respected.The is not evaluated
by this command, so the value will always be 99.
+CSQ :, 99
OK
This +CSQ response, when automatic shots are selected, is sent every time the
measured by the product changes. Automatic shots are supported in idle mode and dur-
ing communication. Combination (addition of the values) of the requested dump (1,2,4,8)
are supported but the activation or deactivation of this flow (8) does not affect the other
flows. Both +CCED and +CSQ responses may then be generated. If the dump> parameter is absent, the last +CCED command parameter (or 15 by default) will
be used.
B A C K