Westermo GD-01 - Manual (Page 154)

154 6196-2220
Command example Possible responses Note
AT +CGQREQ=1,1,4,5,2,14 OK
AT+CGQREQ=? +CGQREG: “IP”, (1-3), (1-4), (1-5), (1-9), (1-31)
+CGQREQ: “PPP”, (1-3), (1-4), (1-5), (1-9), (1-31)
OK
AT+CGQREQ? +CGQREQ: 1,1,4,5,2,14
OK
+CGQMIN – Quality of Service Profile (Minimum acceptable),
(GPRS command)
Description
This command allows the TE to specify a minimum acceptable profile which is checked by
the MT against the negotiated profile returned in the Activate PDP Context Accept mes-
sage.
The set command specifies a profile for the context identified by the local context identi-
fication parameter, . Since this is the same parameter that is used in the +CGD-
CONT command, the +CGQMIN command is effectively an extension to the +CGD-
CONT command.The QoS profile consists of a number of parameters, each of which
may be set to a separate value.
A special form of the set command, +CGQMIN= causes the minimum acceptable
profile for context number to become undefined. In this case no check is made
against the negotiated profile.
The read command returns the current settings for each defined context.
The test command returns values supported as a compound value. If the MT supports
several PDP types, the parameter value ranges for each PDP type are returned on a sep-
arate line.
Syntax:
+CGQMIN=[ [, [, [, [, [,]]]]]]
+CGQMIN?
+CGQMIN=?
Response Syntax:
OK
ERROR
Response on “+CGQMIN?”:
+CGQMIN: , , , , ,
[+CGQMIN: , , , , ,
[...]]
B A C K