Westermo GD-01 - Manual (Page 162)

162 6196-2220
+CGEREP – GPRS event reporting, (GPRS command)
Description
Set command enables or disables sending of unsolicited result codes, +CGEV: XXX from
MT to TE in the case of certain events occurring in the GPRS MT or the network.
controls the processing of unsolicited result codes specified within this com-
mand.
Read command returns the current mode and buffer settings
Test command returns the modes and buffer settings supported by the MT as compound
values.
Syntax:
+CGEREP=[]
+CGEREP?
+CGEREP=?
Response Syntax:
OK
ERROR
Response on “+CGEREP?
+CGEREP:
Response on “+CGEREP=?
+CGEREP: (list of supported s)
Defined values:
0: buffer unsolicited result codes in the MT; if MT result code buffer is full, the
oldest ones can be discarded. No codes are forwarded to the TE.
2: buffer unsolicited result codes in the MT when MT-TE link is reserved
(e.g. in on-line data mode) and flush them to the TE when MT-TE link becomes
available; otherwise forward them directly to the TE
With the current software, a combination of all modes is implemented.When serial
link is available, indications are forwarded directly to the TE. If serial link is reserved
(e.g. in on-line data mode ), if MT result code buffer is full, the oldest ones can be
discarded.
Defined events
The following unsolicited result codes and the corresponding events are defined:
A network request for PDP context activation occurred when the MT was unable
to report it to the TE with a +CRING unsolicited result code and was automatically
rejected.
+CGEV: REJECT ,
B A C K