Sierra Video UPC-166 - Manual (Page 85)

Operating Instructions UPC-166 Function Submenu List and Descriptions
Table 3-2 UPC-166 Function Submenu List —
continued
Audio Group 1 and Embedded Audio Group 2.
while preserving the settings of the channels belonging to the group.
3-41 UPC-166-OM
(V4.0)
(continued)
• SD Audio Depth Allows option of using 24-bit audio data structure per SMPTE 272M,
§3.10 (default is 20-bit per SMPTE 272M, §3.5).
Note: • If 24-bit depth is desired, make certain downstream equipment is
compatible with 24-bit SD audio data.
• Depth control setting applied here affects both Embedded Audio
Group 1/2 and 3/4.
• Group Enable When enabled (On), enables the embedding of the corresponding
embedded audio group (Embedded Audio Group 1 or Embedded Audio
Group 2).
• Embedded Audio Group 1 consists of embedded channels 1 thru 4.
• Embedded Audio Group 2 consists of embedded channels 5 thru 8.
Two Group Enable buttons correspondingly enable or disable Embedded
Disabling a group removes the entire group of embedded audio channels
Note: •
Embedded Ch 2 thru Embedded Ch 8 have controls identical to the Source, Gain, Mute, and Phase controls
described here for Embedded Ch 1. Therefore, only the Embedded Ch 1 controls are shown here.
•
For each channel, its source and destination should be considered and appropriately set. Unused destination
channels should be set to the Silence selection.
• Embedded Channel Source Using the Source drop-down list, selects the audio input source to be
embedded in the corresponding embedded channel from the choices
described below.
Card Edge Control Menu:
Aud
Destination
channel number
Set up to select
Source
1
Embd
2
Grp
3
Ch(n)
4
Src
Card Edge Control Menu:
Aud
1
Embd
2
Grp1
3
Enbl
4
On
Off
Group 1 select
(range is group 1
thru group 4)
On (enabled)
Off (disabled)