Sierra Video UPC-166 - Manual (Page 61)

Operating Instructions UPC-166 Function Submenu List and Descriptions
Table 3-2 UPC-166 Function Submenu
List
component analog over SDI video inputs. Blocks SDI input when
3-17 UPC-166-OM
(V4.0)
Sets the UPC-166 video signal input type and
preference and priority.
• Input Video Preference Sets the input video preference and priority for SDI and analog video
inputs as follows:
• SDI Only: Sets the video input to accept only SDI input. Blocks all
analog video inputs.
• SDI over Analog: Sets the video input to accept SDI over
composite/component analog video inputs. Blocks analog video
inputs when valid signal is received by SDI input.
• Analog Only: Sets the video input to accept only composite and/or
component analog video inputs. Blocks SDI input.
• Analog over SDI: Sets the video input to accept composite/
valid signal is received by composite and/or component analog
video inputs.
• SD Analog Input Type When receiving analog video input, sets the UPC-166 SD input video
type to accept received input signal from choices shown.
Note: Input format must be appropriately set for the UPC-166 to
correctly lock to the input.
• NTSC Contains This setting tells the UPC-166 how much setup (pedestal)
needs to be removed from an NTSC-formatted input.
• 0 IRE of Setup: No setup removed.
• 7.5 IRE of Setup: Removes 7.5 IRE of setup. This is typically
preferred when analog signals containing 7.5 IRE pedestal are
converted to SDI.
Card Edge Control Menu:
Vid
0 IRE pedestal
7.5 IRE pedestal
1
Dec
2
PED
3
0
7.5
Card Edge Control Menu:
Vid
Composite
Y/C
YPbPr BetaCam
YPbPr MII
YPbPr SMPTE
1
Dec
2
SDIN
3
CVBS
Y/C
BETA
MII
SMPT
Card Edge Control Menu:
Vid
SDI only
SDI over Analog
Analog only
Analog over SDI
1
Sorc
2
SDIO
SDIA
ANAO
ASDI