Sierra Video UPC-166 - Manual (Page 69)

Operating Instructions UPC-166 Function Submenu List and Descriptions
Table 3-2 UPC-166 Function Submenu List —
continued
―720p‖ in the ―Scaler Video Format Conversions‖ table on the
instead, perform ARC as described in the AFD function
3-25 UPC-166-OM
(V4.0)
(continued)
• SD: Output Half-rate 720p When drop-down list is set to 720p, converts output to
720p half-rate.
Yes/No control functions as follows:
• No: Do not apply half-rate; leave output at standard frame rate
• Yes: Output set at half- rate
Note: Half-rate outputs are available for the 720p frame rates listed under
previous page.
• SD: Output PsF When enabled (and with the output video is set to 1080 film), converts the
output to1080PsF (segmented frame progressive).
• SD: Aspect Ratio Conversion Selects between the standard preset Aspect Ratio Conversions (ARC)
shown here, as well as User Defined and Follow AFD Settings.
• User Defined settings allow custom user-defined H and V aspect
ratio control.
• Follow AFD Settings sets the output aspect ratio to track with AFD
settings performed in AFD (p. 3-28).
Note: This function is intended for aspect ratio adjustment of a particular
signal without AFD considerations.
• If ARC is being used on a case-by-case basis for a particular
signal, it is easier to use the Scaler ARC tools described here.
• If AFD is to be used to set and apply a standard AFD code label
for ARC, use Follow AFD Settings. Do not perform ARC here;
description on page 3-28.
Card Edge Control Menu:
Sclr
1.0HV (No correction)
0.75H (Pillar Box)
1.33H (Horizontal Center Cut)
0.75V (Letter Box)
1.33V (Vertical Center Cut)
User Defined
Follow AFD Settings
1
SDIn
2
ARC
3
1.0HV
0.75H
1.33H
0.75V
1.33V
User
AFD
Card Edge Control Menu:
Sclr
On
Off
1
SDIn
2
SDSF
3
On
Off
Card Edge Control Menu:
Sclr
Yes
No
1
SDIn
2
H720
3
Yes
No