Sierra Video UPC-166 - Manual (Page 43)

Installation and Setup
Setting Up UPC-166 Network Remote
Control
Table 2-1 UPC-166 Rear I/O Modules —
continued
Setting Up UPC-166 Network Remote
Control
Perform remote control setup in accordance with Cobalt ® reference guide
“COMPASS™ Remote Control User Guide” (PN 9000RCS-RM).
Note: • If network remote control is to be used for the frame and the frame has not
yet been set up for remote control, Cobalt ® reference guide COMPASS ™
Remote Control User Guide (PN 9000RCS-RM) provides thorough infor-
mation and step-by-step instructions for setting up network remote control of
COMPASS
™ cards using DashBoard™. (Cobalt ® OGCP-9000 and
OGCP-9000/CC Remote Control Panel product manuals have complete
instructions for setting up remote control using a Remote Control Panel.)
Download a copy of this guide by clicking on the Support>Downloads link
at www.cobaltdigital.com and then select DashBoard Remote Control Setup
Guide as a download, or contact Cobalt
® as listed in Contact Sierra Video.
(p. 1-29).
• If installing a card in a frame already equipped for, and connected to
DashBoard ™, no network setup is required for the card. The card will be dis-
covered by DashBoard ™ and be ready for use.
2-9 UPC-166-OM
(V4.0)
UPC-166 Rear I/O Module Description
RM-UPC-166-G
UPC-166GA.PNG
Provides the following connections:
• SD-SDI coaxial input (SDI IN)
• Analog Y/composite, Pr/C, and Pb coaxial inputs
(Y/Cmpst, Pr/C, and Pb, respectively)
• Four dedicated AES coaxial audio inputs
(AES IN 5 thru AES IN 8)
• Eight dedicated AES coaxial audio outputs
(AES OUT 1 thru AES OUT 8)
• Four AES I/O coaxial input/outputs (AES I/O 1 thru
AES I/O 4; I/O function of each connection is
user-configurable)
• Eight analog balanced audio inputs (AN-AUD IN 1
thru AN-AUD IN 8)
• Two buffered SDI coaxial outputs (SDI OUT)
Note: AES OUT 1 thru AES OUT 4 on RM-UPC-
166-G Rear I/O Module always function as
outputs regardless of whether AES I/O 1 thru
AES I/O 4 are used as inputs or outputs.