Sierra Video UPC-166 - Manual (Page 37)

Installation and Setup
Installing the UPC-166 Into a Frame
Slot
Note: • If installing the UPC-166 in an 8310-C-BNC or 8310-BNC frame (which
is pre-equipped with a 100-BNC rear I/O module installed across the entire
backplane) or a slot already equipped with a suitable I/O module, proceed to
card installation steps below.
• If installing the UPC-166 in a slot with no rear I/O module, a Rear
I/O Module is required before cabling can be connected. Refer to
Installing a Rear I/O Module (p. 2-4) for rear I/O module installation
procedure.
If required, make certain Rear I/O Module(s) is installed before installing the
UPC-166 into the frame slot. Damage to card and/or Rear I/O Module can
occur if module installation is attempted with card already installed in slot.
Note: Check the packaging in which the UPC-166 was shipped for any extra items
such as a Rear I/O Module connection label. In some cases, this label is
shipped with the card and to be installed on the Rear I/O connector bank
correspond- ing to the slot location of the card.
Install the UPC-166 into a frame slot as
follows:
1. Determine the slot in which the UPC-166 is to be installed.
2. Open the frame front access panel.
3. While holding the card by the card edges, align the card such that the
plastic ejector tab is on the bottom.
4. Align the card with the top and bottom guides of the slot in which the
card is being installed.
5. Gradually slide the card into the slot. When resistance is noticed, gently
continue pushing the card until its rear printed circuit edge terminals
engage fully into the rear I/O module mating connector.
If card resists fully engaging in rear I/O module mating connector, check for
alignment and proper insertion in slot tracks. Damage to card and/or rear I/O
module may occur if improper card insertion is attempted.
6. Verify that the card is fully engaged in rear I/O module mating connector.
7. Close the frame front access panel.
2-3 UPC-166-OM
(V4.0)
CAUTION
CAUTION