Sierra Video UPC-166 - Manual (Page 101)

Operating Instructions UPC-166 Function Submenu List and Descriptions
Table 3-2 UPC-166 Function Submenu List —
continued
re-inserted on the output using the other controls discussed here.)
(1st priority) (w/ ATC_VITC)
3-57 UPC-166-OM
(V4.0)
(continued)
• Timecode Source Status Displays Displays the current status and contents of the four supported timecode
formats shown to the left.
• If a format is receiving timecode data, the current content (timecode
running count and line number) is displayed.
• If a format is not receiving timecode data, Unlocked is displayed.
• Incoming ATC Packet Removal Control Enables or disables removal of existing input video ATC timecode packets
from the output. This allows removal of undesired existing timecodes from
the output, resulting in
a ―clean slate‖ where only desired timecodes are
then re-inserted into the output. (For example, if both SDI VITC Waveform
and SDI ATC_VITC are present on the input video, and only
SDI ATC_VITC is desired, using the Removal control will remove both
timecodes from the output. The ATC_VITC timecode by itself can then be
Note: When the Scaler is enabled, ATC packets are automatically
removed. The Timecode function must be used to re-insert the
timecode data into the output video.
• Source Priority As described here, selects the priority assigned to each of the four
supported formats in the event the preferred source is unavailable.
Each of the four Source Priority selection lists allows assignment of
source priority from the following choices:
Source Priority 1 thru Source Priority 4 select the preferred format to be
used in descending order (i.e., Source Priority 2 selects the second-most
preferred format, and so on. See example below.)
525i SD-SDI IN
SDI VITC 720p
525i ANLG IN
ANLG VITC
(2nd priority)
In this example, SDI VITC 1st priority selection selects SDI VITC (received on SDI
input) over analog VITC (received on analog input) regardless of video input
material source to be processed by the card.
The selected timecode source is embedded on the SDI video output (in this
example, 720p) using the selected line number. In this example, if the SDI VITC
on the SDI input becomes unavailable, the card then uses the 525i analog VITC
data received on the card analog input.
Note: If analog VITC timecode source contains 7.5 IRE of setup, make certain
Video Signal Controls –> NTSC Contains is set to 7.5 IRE of Setup. If
this is not done, analog VITC waveform may not be received and
processed by the card.
SDI
OUT
TC
Card Edge Control Menu:
TC
Priority (1 thru 4)
No source selected
Analog VITC
SDI VITC
ATC_LTC
ATC_VITC
1
PRI(n)
2
None
AVIT
SVIT
ATCL
ATCV
Card Edge Control Menu:
TC
Packet removal disabled
Packet removal enabled
1
Rmvl
2
Off
On