Sierra Video UPC-166 - Manual (Page 102)

3
UPC-166 Function Submenu List and Descriptions
Table 3-2 UPC-166 Function Submenu List —
continued
Make certain the selected line is available and carrying no other
line number.
3-58 UPC-166-OM
(V4.0)
(continued)
• Output Status Display Displays the current content and source being used for the timecode data
as follows:
• Output status OK (in this example, SDI VITC timecode received and
outputted).
• Timecode not available due to lack of appropriate input timecode data on
enabled formats.
Note: Timecode output requires that source and priority are appropriately
selected (as described above in Source Priority). Also, video input
must contain appropriate timecode data.
• Timecode Insertion button set to Disabled; output insertion disabled.
• VITC Waveform Output Line Selects the VITC1 and VITC2 line numbers (6 thru 22) where the VITC
data is inserted.
Note: • Although the output line drop-down will allow any choice within the
6 thru 22 range, the actual range is automatically clamped (limited)
to certain ranges to prevent inadvertent conflict with active picture
area depending on video format. See Ancillary Data Line Number
Locations and Ranges (p. 3-15) for more information.
• The card does not check for conflicts on a given line number.
data.
• If only one output line is to be used, set both controls for the same
• SD VITC Waveform Insertion Control For SD output, enables or disables SD VITC waveform timecode insertion
into the video stream.
• SD ATC Insertion Control For SD output, enables or disables SD ATC_VITC timecode insertion into
the video stream.
Note: SD ATC_VITC is locked to line 12. The card does not check for
conflicts on a given line number. Make certain this line is available if
SD ATC_VITC is to be used. See Ancillary Data Line Number
Locations and Ranges (p. 3-15) for more information.
Card Edge Control Menu:
TC
SD ATC_VITC timecode insertion disabled
SD ATC_VITC timecode insertion enabled
1
SDAT
2
Off
On
Card Edge Control Menu:
TC
SD VITC timecode insertion disabled
SD VITC timecode insertion enabled
1
SDVC
2
Off
On
Card Edge Control Menu:
TC
VITC output 1 line number only
(6 thru 22)
1
VITO
2
(value)