Sierra Video UPC-166 - Manual (Page 38)

2
Installing a Rear I/O Module
8. Connect the input and output cables as follows:
• If the UPC-166 is being installed in a PN 8310-BNC or 8310-C-
BNC frame, refer to the label on the connector bank corresponding
to the card’s slot location for connector designations.
• If the UPC-166 is being installed in a PN 8310-C frame using a UPC-
166 Rear I/O Module (PN RM-UPC-166-A thru RM-UPC-166-G),
connect cabling in accordance with the appropriate diagram shown in
Table 2-1, “UPC-166 Rear I/O Modules” (p. 2-6).
9. Repeat steps 1 through 8 for other UPC-166 cards.
Note: The UPC-166 BNC inputs are internally 75-ohm terminated. It is not
necessary to terminate unused BNC inputs or outputs.
Note: To remove a card, press down on the ejector tab to unseat the card from the
rear I/O module mating connector. Evenly draw the card from its slot.
10. If network remote control is to be used for the frame and the frame has
not yet been set up for remote control, perform setup in accordance with
Setting Up UPC-166 Network Remote Control (p. 2-9).
Note: If installing a card in a frame already equipped for, and connected to
DashBoard ™, no network setup is required for the card. The card will be dis-
covered by DashBoard ™ and be ready for use.
Installing a Rear I/O Module
Note: This procedure is applicable only if a Rear I/O Module is not currently
installed in the slot where the UPC-166 is to be installed.
If installing the UPC-166 in a 8310-C-BNC or 8310-BNC frame (which is
pre-equipped with a 100-BNC rear I/O module installed across the entire
backplane) or a slot already equipped with a suitable I/O module, omit this
procedure.
The full assortment of UPC-166 Rear I/O Modules is shown and
described in UPC-166 Rear I/O Modules (p. 2-6). Install a Rear I/O
Module as follows:
1. On the 8310 frame, determine the slot in which the UPC-166 is to be
installed.
2. In the mounting area corresponding to the slot location, install
Rear I/O Module as shown in Figure 2-2.
2-4 UPC-166-OM
(V4.0)