Sierra Video UPC-166 - Manual (Page 35)

Chapter 2
Installation and Setup
Overview
This chapter contains the following information:
• Setting I/O Switches for AES I/O (1-4) Ports (p. 2-1)
• Installing the UPC-166 Into a Frame Slot (p. 2-2)
• Installing a Rear I/O Module (p. 2-4)
• Setting Up UPC-166 Network Remote Control (p. 2-9)
Setting I/O Switches for AES I/O (1-4) Ports
Note: This procedure is applicable only if any of the four AES I/O (1-4) ports on the
UPC-166 are to be used as outputs (the switches are set to input mode by
factory default). The UPC-166 is equipped with a four-section red DIP switch
that sets AES pairs 1 thru 4 as either inputs or outputs. The factory default
position is the input position for each pair.
• If all of the AES I/O (1-4) ports are to be used as inputs (or not used at all),
omit this procedure.
• If any of the AES I/O (1-4) ports are to be used as outputs, set the switches
as described in this procedure.
Note switch S11 thru S14 settings for AES I/O 1 thru AES I/O 4 mode shown
in Figure 2-1. For port to be used as an output, set switch to down position as
shown in Figure 2-1.
Note: Regardless of S11 thru S14 settings for AES I/O 1 thru AES I/O 4, outputs
AES OUT (1-8) are still available on cards equipped with a Rear I/O Module
having dedicated AES OUT (1-8) BNC connectors.
2-1
UPC-166-OM
(V4.0)