Comtech EF Data SDM-2020 - Manual (Page 79)

SDM-2020 Satellite Demodulator Revision 4
Front Panel Operation MN/SDM2020D.IOM
6–15
Function Select: Configuration: Demodulator: Reacquisition
REACQUISITION
0 SECONDS
Programs the sweep reacquisition mode time duration. This is the time that the
demodulator will remain in a narrow sweep after loss of acquisition. After this time runs
out, the demodulator will return to the normal acquisition sweep. The reacquisition time
is from 0 to 999 seconds.
Upon entry, the current programmed setting is displayed with a flashing cursor on the
first character. Press [
↑] or [↓] to increment or decrement the digit at the flashing cursor.
Select the number of seconds desired for the reacquisition mode. Press to
execute the change.
Function Select: Configuration: Demodulator: RF Input Select
(Conditional)
RF INPUT SELECT
1
Programs the selected channel as 1, 2, 3, or 4. (L-Band only.)
IMPORTANT
Only available with the 4-Channel card installed
On entry, the current RF Input Channel is displayed. Press[ ↑] or [↓] to select the desired
setting. Press to execute the change.