Comtech EF Data SDM-2020 - Manual (Page 213)

SDM-2020 Satellite Demodulator Revision 4
Remote Control Commands MN/SDM2020D.IOM
A–13
A.1.10 System Configuration Commands/Responses
Time Of Day Command:
Response:
Status:
Response: >add/TIME_hh:mmxx'cr''lf']
>add/TIME_hh:mmxx'cr''lf'] Where:
hh = 1 to 12 (hours).
mm = 00 to 59 (minutes).
xx = AM or PM.
Date Command:
Response:
Status:
Response:
>add/DATE_mm/dd/yyyy'cr''lf']
>add/DATE_mm/dd/yyyy'cr''lf'] Where:
mm = 1 to 12 (month).
dd = 1 to 31 (day).
yyyy = See Note
Note: 00 to 99 (year) in 2-digit year mode and
1975 to 1999 and 2000 to 2075 in 4-digit year
mode.
Remote
Configures the
MODEM for
Remote
Operation
Command:
Response:
>add/REM_'cr''lf']
The demodulator will respond to any status
request at any time. However, the demodulator
must be in 'Remote Mode' to change
configuration parameters.
Clear Stored
Faults
Command:
Response:
>add/CLSF_'cr''lf'] This command is used to clear all stored faults
logged by the demodulator.
Save Modem
Config.
Command:
Response:
>add/SMC_nn'cr''lf']
Where: n = 1, 2, 3, ..., 10 (stored configuration
number).
This command saves the current demodulator
configuration for recall at a later time using the
'RMC_' command. Up to ten different
demodulator configurations can be saved.
Recall Modem
Config. Command:
Response:
>add/RMC_nn'cr''lf']
Where: n = 1, 2, 3, ..., 10 (stored configuration
number).
This command causes the demodulator to be
reprogrammed with configuration parameters
previously saved using the 'SMC_' command.
One of ten saved configurations can be
specified.