Comtech EF Data SDM-2020 - Manual (Page 231)

SDM-2020 Satellite Demodulator Revision 4
Remote Control Commands MN/SDM2020D.IOM
A–31
A.1.16.5 ASI/LVDS Interface Commands
Interface Select
Command Command:
Response:
Status:
Response: >add/ISEL_xxxx'cr''lf']
>add/ISEL_xxxx'cr''lf']
Where: xxxx = ASI or LVDS
Interface
loopback Command:
Response:
Status:
Response: >add/ILB_xxx'cr''lf']
>add/ILB_’cr’
>add/ILB_xxx’cr’’lf’]
Where: xxx = On or Off
Interface
Firmware
Information Command:
Response:
>add/IFI_'cr''lf']
FW/nnnnn-dr’cr’
mm/dd/yyyy’cr’’If’]
Where: nnnnnn = Firmware number (0 to 999999).
d = Firmware dash number (0 to 99)
r = Firmware revision (-, or A to Z)
DCP Command
Configuration Command:
Response: >add/DCP_’cr’
ISEL_xxxx’cr’
RDVB_xxxx’cr’
DF_nnnn.nnnn’cr’
DR_nnnn.mmm.mmmmmm’cr’
DE_xxx’cr’
RCP_xxx’cr’
RDP_xxxx’cr’
RDF_xxxx’cr’
SWR_nnnnnnnn’cr’
SR_xxx’cr’
RFIN_x’cr’ (Note)
LNBV_xx’cr’’lf’] (Note)
Interface Select
DVB Framing Type
Demodulator Frequency
Demodulator Rate
Descrambler Enable
Receive Clock Phase
Receive Data Phase
Receive Data Fault
Sweep Width Range
Sweep Reacquisition
RF Input Select
LNB Voltage Select
Note: Only displayed if the 4-channel RF carf is installed.
ICS Command
Configfuration Command:
Response: >add/ICS_’cr’
RCP_xxx’cr’
RDP_xxxx’cr’
RDF_xxxx’cr’
RDVB_xxxx’cr’
INID_xxxxxxxxx’cr’
ISEL_xxxxxx’cr’
ILB_xxx’cr’
Receive Clock Phase
Receive Data Phase
Receive Data Fault
DVB Framing Type
Interface ID
Interface Select
Interface Loopback
IJ1 Interface
Jumper #1
Setting Command:
Response: >add/IJ1_xx’cr’’lf’] Where xx = TX or RX (LVDS)
Thisd status only command will display the current jumper
setting on the ASI/LVDS PCB. This is a hardware configuration
only.