Comtech EF Data SPOD PS 1, PS 1.5, and PS 2 C-, X-, or Ku-Band - Manual (Page 76)

SPOD C-, X-, or Ku-Band Outdoor Amplifier MN-SPODPSX
Ethernet-based Remote Product Management Revision 1
4–18
Click [Submit SNMP] to save any changes. Otherwise, click [Reset] to revert to the previously
assigned SNMP designations.
4.5.4.3 Config Pages
The CONFIG | LNB page is inoperable for the SPOD PS2. For this reason, while the
LNB page hyperlink is visible and selectable on this interface, it is not documented
in this manual.
Click the Config tab, and then click the Amplifier, Utility, or Redundancy hyperlink to continue.
4.5.4.3.1 Config | Amplifier
Use this page to configure the communications, operations, and alarms/faults handling for the
amplifier.
Figure 4-6. Config | Amplifier Page
Click [Refresh] (at the top of the page) to update the page appearance to the current operating
configuration.
The Reference and FSK Address sections of this page are non-functional on the SPOD
Web Server Interface.