Comtech EF Data SPOD PS 1, PS 1.5, and PS 2 C-, X-, or Ku-Band - Manual (Page 43)

SPOD C-, X-, or Ku-Band Outdoor Amplifier MN-SPODPSX
System Connections, Installation and Startup Revision 1
2–9
2.3.6 Connector ‘J9 | OUTPUT SAMPLE’ (PS 2 Only)
The ‘J9 | OUTPUT SAMPLE’ port is a Type ‘N’ female connector
available only on the PS 2 unit. It provides a nominal -40 dB
sample of the output signal. A calibration label is provided near
the connector that shows the actual coupling values vs.
frequency.
2.3.7 Ground Connector
A #10-32 stud is provided at the locations shown in Figure 2-6 for connecting a
common chassis ground among equipment.
Figure 2-6. SPOD Ground Connections