Comtech EF Data SPOD PS 1, PS 1.5, and PS 2 C-, X-, or Ku-Band - Manual (Page 179)

SPOD C-, X-, or Ku-Band Outdoor Amplifier MN-SPODPSX
Appendix B Revision 1
B-9
B.3.1 RF Cable (Type ‘N’)
Use this Type ‘N’ cable for the Rx or Tx connections in SPOD Standalone or 1:1 Redundancy applications:
• For SPOD PS 1 C-Band and X-Band applications – For Standalone use, the cable connects the unit’s ‘J2 | RF OUT’ port directly to your Rx
signal destination. For 1:1 Redundancy applications, use the cable to connect each SPOD’s ‘J2 | RF OUT’ port to the Tx Waveguide switch.
• For all SPOD applications – For Standalone use, the cable connects directly from these SPOD interfaces to your Rx signal destination or Tx
signal source. For 1:1 Redundancy applications, use the cable to connect the ‘J1 | LBAND IN / Tx IN’ or ‘J10 | MODEM Rx’ ports in 1:1
Redundancy applications to the system’s respective signal splitters.
Figure B-6. 1/4" Heliax Coaxial Cable (CA/3722-X)