Comtech EF Data SPOD PS 1, PS 1.5, and PS 2 C-, X-, or Ku-Band - Manual (Page 109)

SPOD C-, X-, or Ku-Band Outdoor Amplifier MN-SPODPSX
Serial-based Remote Product Management Revision 1
5–17
Parameter Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
(Note that all arguments are printable ASCII characters)
Response to
Command
(Target to
Controller)
Query
(Instruction
Code and
Qualifier)
Response to Query
(Target to
Controller)
Initialize Events
Pointer
IEP= None Command only.
Resets internal pointer to allow RNE? queries to start at the beginning of the stored events log.
Example: <1/IEP=’cr’
>0001/IEP=’cr’lf
IEP=
IEP?
IEP*
N/A N/A
Software Image IMG= 1 byte Command or Query.
Sets or returns the current active software image in the form x, where:
1=Bulk Image # 1 currently active
2=Bulk Image # 2 currently active
Note: if you send the IMG command, and then query the IMG value the numbers may not be equal because the
command tells the firmware which image to boot from at the next bootup, and the query reports the image that the
firmware booted from on the last bootup.
Examples:
<1/IMG=1’cr’ (instructs the unit to load firmware from image #1 at the next reset / power up).
<1/IMG?’cr’ (queries the image number that the firmware loaded during bootup)
IMG=
IMG?
IMG*
IMG#
IMG? IMG=x
(See Description of
Arguments)
IP Address IPA= 18 bytes Command or Query.
Sets or returns the IP address and network prefix for the 10/100 BaseT Ethernet management port, in the form
xxx.xxx.xxx.xxx.yy, where:
xxx.xxx.xxx.xxx is the IP address, and
yy is the network prefix (8-30)
Default value: 192.168.001.004.24
Note: Changing the IP address through the Telnet interface requires the user to power cycle the unit, and then
restart a new Telnet session with the new IP address. The IP address that you type into the Telnet client
software does not include the range parameter so it would be: 192.168.1.4
Example: <1/IPA=192.168.001.004.24’cr’
>0001/IPA=’cr’’lf’
IPA=
IPA?
IPA*
IPA#
IPA? IPA=
xx.xxx.xxx.xxx.yy
(See Description of
Arguments)
Gateway Address IPG= 15 bytes Command or Query.
Sets or returns the Gateway IP address for the 10/100 Base Tx Ethernet management port, in the form
xxx.xxx.xxx.xxx.
Default value: 192.168.001.005
Example: <1/IPG=192.168.001.005’cr’
>0001/IPG=’cr’’lf’
IPG=
IPG?
IPG*
IPG? IPG =
xxx.xxx.xxx.xxx