Avery Dennison 9406 System Administrator Guide - Manual (Page 53)

Defining Lines as Vectors
1. Follow the steps to define lines as segments with the
exception of boxes L2, L5, and L6.
2. Write V in box L2.
3. In box L5, write the direction the line travels from its origin:
0, 90, 180, or 270 (in degrees).
4. Write the length of the line, in your specified units, in box
L6.
Defining Boxes
1. Define the format as
shown in this chapter, if
you have not already
done so.
2. Find "Boxes" on the Format
Worksheet. Measure from the
bottom of the print area to the
lower left corner of the box.
Write the distance, in the units
selected for your format, in box
Q2. Ranges:
English 0-800
Metric 0-2032
Dots 0-1536
3. Measure from the left edge of the
print area to the lower left corner of
the box. Write the distance, in your
selected units, in box Q3. Ranges:
English 0-400
Metric 0-1118
Dots 0-768
Desi
g
n
in
g
a
F
o
rmat
2. Designing a Format
2-39