Avery Dennison 9406 System Administrator Guide - Manual (Page 24)

3. You must send this format to the printer before you can
use it to print batches. Decide how the printer will store the
format. You have two choices.
R Store format until printer is turned off.
T Store format only until the printer uses another format.
Write your choice in box F4.
4. What system are you using to measure supplies and
fields? You have three choices.
E English. Measure in 1/100 inches.
M Metric. Measure in 1/10 millimeters.
G Graphic. Measure in dots. 192 dots = 1 inch.
Write your choice in box F5.
All fields in the format must follow the system you select
here.
5. Tear off one label or tag from your supply roll. Position it in
the lower left corner of the grid.
If you are using non-indexed supplies (supplies with no
black mark or aperture), determine the length you want to
use for each format.
If you are using indexed supplies (that have black marks or
apertures), use the black mark or aperture as your
reference for the format length.
Make sure the bottom left corner of the supply aligns with
the lower left corner of the layout grid (the bottom is the
edge that exits the printer first).
NOTE: See "The Print Area," in this chapter, for a
description of the no-print zones.
9406 System Administrator’s Guide
2-10