Avery Dennison 9406 System Administrator Guide - Manual (Page 33)

12. You can alter space between characters. This space is
measured in dots (1/192 inch). Write the number of dots
(0 to 99) in box T7. Enter 0 for default character spacing.
Any number other than 0 or the default number will affect
your field width.
Default spacing:
Standard 3 dots
Reduced 1 dot
Bold 3 dots
The character width chart earlier in this procedure reflects
default spacing.
13. Write 1, 2, or 3 in box T8 to indicate your font selection.
Refer to the table earlier in this procedure for samples.
Note that the bold font does not accept lowercase letters.
1 Standard font
2 Reduced font
3 Bold font
14. Write a number from 1 to 7 in box T9 to indicate the
number of times to magnify character height. Refer to the
table ealier in this procedure. Enter 1 to use the standard
size.
15. Write a number from 1 to 7 in box T10 to indicate the
number of times to magnify character width. Refer to the
table earlier in this procedure. Enter 1 to use the standard
size.
Desi
g
n
in
g
a
F
o
rmat
2. Designing a Format
2-19