Avery Dennison 9406 System Administrator Guide - Manual (Page 20)

The Print Area
If you use supplies larger than four inches wide, your printer
may not print an area that covers the entire supply.
The print area is in the center of the supply. The bottom is the
edge that exits the printer first.
The actual print area begins approximately 0.161 inches from
the bottom, 0.125 inches from the left edge, and .031 inches
from the top of the supply. These are the no-print zones. If you
are using die cut labels, you must also include the inter-label
gap as a no-print zone. For supplies wider than the printhead,
there is another no-print zone along the right edge 3.98 inches
across from the left edge no-print zone. The no-print zones are
the same for both indexed and non-indexed supplies. See the
diagram below.
If you want to shift printing to a different part of the supply, see
"Setting Supply Options" in your
Operator’s Handbook.
3.98" x 8.0"
(101 mm x 203 mm)
Print Area
4.2" (107 mm)
8
.3
2
" (
2
1
1
mm)
.031"
(.8 mm)
.161"
(4.1mm)
.125"
(3.2 mm) .094"
(2.4 mm)
9406 System Administrator’s Guide
2-6