Avery Dennison 9406 System Administrator Guide - Manual (Page 103)

At the Host
On PC-DOS/MS-DOS computers, use the MODE command to
set communication values. For example,
MODE COM1:9600,N,8,1,P
This command sets these communication values for a printer
connected to COM port 1:
•
9600 baud
•
No parity
•
8 bit word length
•
1 stop bit
•
P means to ignore the time-out signal, ensuring that
large data streams will be sent in their entirety.
Consult your DOS manual for more information on setting
communication values.
Consult your System Administrator to set communication
values on other hosts.
C
onf
igur
ing t
h
e
P
rin
te
r
7. Configuring the Printer
7-5