Avery Dennison Monarch 9864 Error Messages - Manual (Page 66)

05/08 Rev. AB USER MANUAL Error Messages
9844 – 9854 – 9864
66
9018 #!CA wrong Pos.
Status The #!CA command is placed at an invalid position – Easy Plug cannot
process the command at this position (for example, while loading files onto
a Compact Flash card).
Action Call the #!CA command at a valid position.
9020 Param. ID wrong
Status A non-existing parameter ID was used.
Action Correct the parameter ID.
9022 No network link
Status This message occurs when the Ethernet address assign is set to DHCP.
The cause is usually a bad network connection.
Action Check if the network connector is plugged in properly.
9024 Not possible !
Status Detecting the material length (a function, which is normally used with MLI is
not possible, because a printjob is currently processed).
Action Retry as soon as the printjob is processed.
9030 Log file:CF full
Status An attempt to store data on the Compact Flash card was not successful,
because of a full card.
Action Clear some storage space on the Compact Flash card.
Load an empty card.
9031 Log file: nnnn
Status File access error. nnnn = error code of the operating system.
Action Repeat the operation. If the message reappears, send a message to
Service including the error code.
9032 EP file log stop
Status Someone tried to send data after an error message appeared. This
deactivates the Easy Plug file logging.
Action Reactivate the file logging.
9034 Use min 16MB RAM
Status The printer does not have enough RAM. The applied firmware version
needs at least 16 MB RAM for operation.
Action Extend the printer's RAM.