Avery Dennison Monarch 9864 Error Messages - Manual (Page 40)

05/08 Rev. AB USER MANUAL Error Messages
9844 – 9854 – 9864
40
5026 Motorprotect CPU
Status (9854 only) The motor driver board (output stage board) is overheated or
defective.
Action Turn off the printer, wait 30 seconds, then turn it back on.
If the error message continues to appear, replace the motor driver board.
5028 PS overheat
(9854 only)
Status The temperature inside the power supply exceeds the limit.
Action Let the power supply cool down.
5060 Stacker full
Status This message only appears if a stacker is applied as peripheral device and
indicates the stacker is full or the protection cover is opened.
Action Empty stacker
Close cover
If the message appears when the cover is closed and the stacker is empty,
check the function of lid switch and micro switch.
5061 Dispenser motor
Status The output stage board for the dispenser motor is not present or defective.
Action Press Online to acknowledge.
Check the output stage board for the dispenser motor and exchange it.
5062 Disp. lift motor
Status The output stage board for the dispenser lift motor is not present or
defective.
Action Press Online to acknowledge.
Check the output stage board for the dispenser lift motor and exchange it.
5063 Press roll
Status Dispenser version: press roll is not closed.
Action Close the press roll.
5064 Backing paper
Status (Dispenser version printers) Appears when the diameter of the rewinded
backing paper roll has become too large.
Action Clear the internal liner takeup roller.
Press Online to acknowledge.