Avery Dennison Monarch 9864 Error Messages - Manual (Page 46)

05/08 Rev. AB USER MANUAL Error Messages
9844 – 9854 – 9864
46
5204 Start delay
Status The applicator received another start signal while printing/applying a label.
Precondition: Parameter
APPLICATOR PARA > Start error stop
or
DP INTERFACE > Start error stop
is set to On.
Action Check the labelling procedure, increase the product distance.
Set parameter Start error stop to Off.
5205 Applicator gen.
Status General software error
Action See notes in “General software errors” section.
5206 Applicator resp.
Status Communication with the AI exceeded a given time frame.
Action Turn off the printer and on again after 30 seconds. If the error still occurs
after several tries, contact Technical Support.
5207 Appl. driver 1
Status Shortcut or overheat at power output 1 of the AI.
Action Check the connections.
5208 Appl. driver 2
Status Shortcut or overheat at power output 2 of the AI.
Action Check the connections.
5209 Appl. driver 3
Status Shortcut or overheat at power output 3 of the AI.
Action Check the connections.
5210 Appl. driver 4
Status Shortcut or overheat at power output 4 of the AI.
Action Check the connections.
5500 Unknown
Status General software error
Action See notes in “General software errors” section.
5501 General
Status General software error
Action See notes in “General software errors” section.