Avery Dennison Monarch 9864 Error Messages - Manual (Page 39)

05/08 Rev. AB USER MANUAL Error Messages
9844 – 9854 – 9864
39
Try again. If the error message continues to appear, exchange the power
supply.
Call Service for more information.
5018 Dot check area
Status The current measurement circuit inside the power supply delivers a value
which is too high. This can be a power supply defect or a printhead dot has
too low resistance.
Action Press Online to acknowledge.
Try again. If the error message continues to appear, contact Service.
5020 I2C Timeout xx
Status Timeout error during communication via the I 2 C bus with the printer.
Action Turn off the printer, wait 30 seconds, then turn it back on. If the error
message continues to appear, contact Service.
5021 I2C Conf. xx
Status Confirmation error during communication via the I
2
C bus with the printer.
Action Turn off the printer, wait 30 seconds, then turn it back on. If the error
message continues to appear, contact Service.
5022 I2C Busy xx
Status Error during communication via the I 2 C bus with the printer. Printer always
reports that it is busy.
Action Turn off the printer, wait 30 seconds, then turn it back on. If the error
message continues to appear, contact Service.
5023 I2C LAB xx
Status Error during communication via the I 2 C bus with the printer.
Action Turn off the printer, wait 30 seconds, then turn it back on. If the error
message continues to appear, contact Service.
5024 I2C BER xx
Status Error during communication via the I 2 C bus with the printer.
Action Turn off the printer, wait 30 seconds, then turn it back on. If the error
message continues to appear, contact Service.
5025 I2C Polling xx
Status Polling error during communication via the I
2
C bus with the printer.
Action Turn off the printer, wait 30 seconds, then turn it back on. If the error
message continues to appear, contact Service.