Avery Dennison Monarch 9864 Error Messages - Manual (Page 37)

05/08 Rev. AB USER MANUAL Error Messages
9844 – 9854 – 9864
37
5008 Ribbon end
Status Ribbon end
Action • When using thermal printing:
1. Check whether the parameter
SYSTEM PARAMETER > Ribbonautoecon.
is set to
"deactivated".
2. Press Online to acknowledge.
3. Turn off the ribbon end detection,
parameter:
SYSTEM PARAMETER > Ribbonautoecon
.
4. Press Online: processing of the job continues, gap LS is reinitialized.
•
When using heat transfer printing:
Action 1
1. Tighten ribbon or set the spring plate on the ribbon unwind reel so the
ribbon core turns the reel with it and the ribbon core can still be removed.
2. Press Feed to acknowledge the status report.
Display: OFFLINE x JOBS
3. Press Online: processing of the job continues, gap LS is reinitialized.
Action 2
1. Press Cut to deactivate the sound.
2. Press Feed to acknowledge the status report.
Display: OFFLINE x JOBS
3. Load a new ribbon.
4. Press Online: processing of the job continues, gap LS is reinitialized.
5009 USI start error
Status This status message can only be triggered with activated parameter
DP INTERFACE > Start error stop
. It occurs when another start signal is given
while printing a label.
Action Press Online to acknowledge. Press Feed to continue with the print job.
5010 Paper jam
Status There is a paper jam.
Action Press Online to acknowledge.
In case of false triggering, increase the setting of the paper jam level.
See parameter
SERVICE FUNCTION > Paper jam level
.